1. 圣陽蓄電池具有優良的防酸及排氣性能，當壓力超過正常值時應可靠排氣，壓力恢復正常值時應可靠密封，無論在任何情況下應確保排出的氣體不含酸霧；

2. 圣陽蓄電池容量應按國家規定的方法試驗，10h率容量應在第一次循環不低于0.95C10，第五次循環應達到C10，放電終止電壓應為1.8V。日自放電率小于額定容量的0.1％或月自放電率小于額定容量的4％；

3. 圣陽蓄電池應密封良好，無論立放或臥放均無電解液溢出；

4. 圣陽蓄電池采用組架安裝,并安裝于蓄電池室。圣陽電源廠家應標示每個蓄電池的序號和組別。

5. 圣陽蓄電池可以大電流放電，蓄電池以30I10的電流放電1min，極柱不應熔斷，其外觀不得出現異常；

6. 圣陽蓄電池靜置90d后，荷電保持能力標準公式計算不低于80%，完全充電的蓄電池表面應清潔；

7. 圣陽電池密封反應效率：密封反應效率不低于95%。

1. Shengyang battery has excellent anti-acid and exhaust performance, when the pressure exceeds the normal value should be reliable exhaust, pressure to normal value should be reliable sealing, in any case should ensure that the discharged gas does not contain acid fog;

2. Shengyang battery capacity should be tested according to the national provisions of the method, 10H rate capacity should not be less than 0.95C10 in the first cycle, the fifth cycle should reach C10, discharge termination voltage should be 1.8V. The daily discharge rate is less than 0.1% of the rated capacity or the monthly discharge rate is less than 4% of the rated capacity;

3. Shengyang battery should be well sealed, regardless of vertical or horizontal electrolyte overflow;

4. Shengyang battery is installed by the group frame and installed in the battery room. Shengyang power supply manufacturers should mark the serial number and group of each battery.

5. Shengyang battery can large current discharge, battery to 30I10 current discharge for 1min, pole pole should not fuse, its appearance shall not appear abnormal;

6. Shengyang battery standing for 90 days, the charge retention capacity standard formula calculation is not less than 80%, fully charged battery surface should be clean;

7. Sealing reaction efficiency of Shengyang battery: Sealing reaction efficiency shall not be less than 95%.